To start a manual search of channels to use the arrows Up or Down on the remote control switch to the menu item ‘Start Search box and click “OK”. After the search to confirm the preservation of channels found (by pressing the cursor left and click “OK”). Pressing the Exit, close the menu. Receiver set. If there were problems with all channels Tricolor, then reset receiver to the factory: Turn on your receiver. Click on the remote control button ‘Menu “. The Main Menu receiver. Click ‘OK “to enter the submenu” Settings “. Enter the desired pin (factory setting pin – 0000). C arrows Up or Down on the remote control go to the menu item “Factory settings” and click “OK”. A warning appears on the full reset settings on your receiver. Press the red button i. In dialog box appears, confirm the settings reset (by pressing the cursor left and click “OK”). Wait about one minute until the reset occurs. Turn on the receiver button on the remote control.
Click ok three times to start the automatic channel search. During the automatic search you can see a list of found channels in the left pane and a list of channels on the right side. You can stop the Automatic search to the end (you need to press the Exit, and then “OK”) and use the “Manual Search”, as described below. Click on the remote control button Menu. Click ok to sign in submenu “Configuration”. Enter the desired pin (factory setting pin – 0000). Use the arrow keys “Up” or “Down” on the remote control go to the menu item “Manual Search” and click “OK”. In the “manual search” you must verify that the menu item “Frequency” is set to 12,226 (or 12,225). If set to another value, you must go to the menu item and using the number buttons of remote control to enter value of 12,226. Also check the option “flow rate” and if necessary, set the value of 27,500. To start a manual search of channels to use the arrows Up or Down Remote Control go to the menu item ‘Start Search box and click “OK”. After the search is necessary to confirm the preservation of channels found (by pressing the cursor left and click “OK”). A few clicks of the button Exit Exit the menu. Setting completed.